diff --git a/Makefile b/Makefile index f363176..f2996fe 100644 --- a/Makefile +++ b/Makefile @@ -11,7 +11,7 @@ build: deps dist/setup-config ln -sf dist/build/propellor/propellor deps: - @if [ $$(whoami) = root ]; then apt-get -y install gpg ghc cabal-install libghc-missingh-dev libghc-ansi-terminal-dev libghc-ifelse-dev libghc-unix-compat-dev libghc-hslogger-dev; fi || true + @if [ $$(whoami) = root ]; then apt-get -y install gnupg ghc cabal-install libghc-missingh-dev libghc-ansi-terminal-dev libghc-ifelse-dev libghc-unix-compat-dev libghc-hslogger-dev; fi || true dist/setup-config: propellor.cabal cabal configure diff --git a/README b/README index cc02789..c46131b 100644 --- a/README +++ b/README @@ -9,7 +9,7 @@ The design is intentionally very minimal. Propellor lives in a git repository, and so to set it up it's cloned to a system, and "make" can be used to pull down any new changes, and compile and run propellor. This can be done by a cron job, or -something can ssh in and run it. +a local propellor on your laptop can ssh in and run it. Properties are defined using Haskell. Edit config.hs to get started.